Introduction of InnoDisk FiD 2.5” SATA 10000

InnoDisk FiD 2.5” SATA 10000 products provide high capacity flash memory Solid State Drive (SSD) that

electrically complies with Serial ATA (SATA) standard. InnoDisk FiD 2.5” SATA 10000 supports SATA II

standard (3.0GHz) with high performance. For SLC solution, sustain read is at 160 MB per second (max.), and

sustain write is at 140 MB per second (max). InnoDisk FiD 2.5” SATA 10000 uses standard 2.5-inch form

factor, which can be used in laptop. InnoDisk FiD 2.5” SATA 10000 is designed for industrial field. The SSD

have good performance, no latency time and small seek time. It effectively reduces the booting time of

operation system and the power consumption is less than hard disk drive (HDD). InnoDisk FiD 2.5” SATA

10000 can work in harsh environment. The SSD is vibration resistance, and can work in lower or higher

temperature than HDD. InnoDisk FiD 2.5” SATA 10000 complies with ATA protocol, no additional drives are

required, and the SSD can be configured as a boot device or data storage device.

1.2 Product View

Figure 1: InnoDisk FiD 2.5” SATA 10000

1.3 Product Models

InnoDisk FiD 2.5” SATA 10000 is available in follow capacities.

FiD 2.5” SATA10000 8GB (SLC)

FiD 2.5” SATA10000 16GB (SLC)

FiD 2.5” SATA10000 32GB (SLC)

FiD 2.5” SATA10000 64GB (SLC)

FiD 2.5” SATA10000 128GB (SLC)

1.4 SATA Interface

InnoDisk FiD 2.5” SATA 10000 support SATA II interface, and compliant with SATA I. SATA II interface can

work with Serial Attached SCSI (SAS) host system, which is used in server computer. InnoDisk FiD 2.5” SATA

10000 is compliant with Serial ATA Gen 1 and Gen 2 specification (Gen2 supports 1.5Gbps /3.0Gbps data rate).

SATA connector uses a 7-pin signal segment and a 15-pin power segment.

InnoDisk FiD 2.5” SATA10000 for SLC Solution

10 Ver1.8 Datasheet, November 2009

1.5 2.5-inch form factor

Industry 2.5-inch standard form factor design with metal material case is easy for installation because 2.5-inch

is a popular form factor in industrial field. 2.5-inch is most laptop’s hard disk’s form factor. InnoDisk FiD 2.5”

SATA 10000 SSD can easy install in laptop. InnoDisk FiD 2.5” SATA 10000 has a compact design 99.88mm (L)

x 69.63mm (W) x 9.3mm (H).

1.6 Capacity

InnoDisk FiD 2.5” SATA10000 provides unformatted 8GB, 16GB, 32GB, 64GB, and 128GB capacities within

SLC flash ICs.